I am currently working for a company in Mojave as a Landing Gear Systems Engineer and have a question regarding Skydrol and what effects it has on composites.
I have been searching the internet intensely and have not found much info on the subject.
The direct question is that I have a 75,000...
Hello to all,
I am trying to set the dimension callout so that there is no extended line with arrows out. I attached a file that shows the dimension but I want to eliminate the short overruns of the dimension line on the opposite side of the arrowheads. I know that CATIA does this by default...
Hello to all,
My next question is a CATIA question. I know how to appy material to the part body but what I would like to do is to have the material to be visible on the part body. Hope this makes sense.
CATIA V5 Rev 19
thanks,
Jerry
Hello to all,
My next question is a CATIA question. I know how to appy material to the part body but what I would like to do is to have the material to be visible on the part body. Hope this makes sense.
CATIA V5 Rev 19
thanks,
Jerry
I have a drawing that is calling out S. R. and it does not refer to a sherical radius. It is on a Test Enable switch which is on a Thrust Reverse assy.
Thanks for the help in advance.
Jerry Eden
I know this has been talked about before a few months ago but I would like to resurrect the topic. I want to have a crosshair in my graphics window and was wondering if anyone knew how to change this option?
Thanks in advance,
Jerry
I am looking for an Industry standard that calls out the edge distance of fasteners. I was wondering if there is anyone out there who may know of the spec?
Thanks,
What I am trying to accomplish is eliminate hydraulic fluid in landing gear actuators and use nitrogen to produce extend and retract. The actuators have an internal lock system that locks the gear down and when the gear are retracted the hydraulic fluid pressure releases the internal lock. If it...
I am designing a part that is Titanium 6-4 and a shaft made of MP35N to be press fit into Ti part. The shaft is .625 and needs to be symmetrical in Ti part that is about 1.5 in long supports the shaft. The shaft is approx 7 inches long so needs to be pressed about 3.5 inches. The question that...
I am new to NX2 and need some help on defoming a part or maybe their is another way to accomplish assembly features without modifying the detail part.
What I am trying to accomplish is modify a part feature in the assembly without modifying the operations or features in the detail part. An...
I am trying to align a non aligned view to a current view on a drawing. I tried using the set relative position but it does not lock the view in position and I cannot align the views using common geometry. Any help would be appreciated.
Thanks,
Jerry
