I am trying to source an accepted aeronautical alt for Amercoat 1403. This is to seal cork floats on vent valves in jetfuel. I am trying to find info on Amercoat (contacted PPG) but maint manual says Amercoat or equivalent maybe PR1005L will suffice. Any ideas????
I am trying to source a tool and or drawings for the setting of MS20230 eyelets or grommets in some areas.
Most tooling around will set the commercial type with a straight barrel not the tapered type on the MS.
(AN230 was the old spec)
Size is 0 and it is a plain washer (Al or Brass per spec)...
On Jo Bolt (NAS1669 nominal)protruding head type I have installed iaw material thickness and selected appropriate grip in the various sizes I am using -3,-4,-5. The fasteners break off within limits and those that i can see have a good head form. Problem is they rotate. Now does anyone know of a...
I am trying to source an alt part to one that is prescribed in the IPB for P3B. Pno 920372-5. It is a water drain off the overboard bleed air duct and must conform to LAC-23-952.
it has dim of .5inch ID and .125inch wall thickness.
The spec states that it is tested at 400F and as it is close to...
