See the attached image for the staggered offset fillet weld I want to be applied. The black blobs are weld bead.
I found a site that shows the image in the lower right hand corner, but the weld is different than what I want. It shows the start of the second bead at the end of the first bead...
Please see the attached image. I made an extrude cut of a triangle on a diagonal of the cube. Can I make the same geometry with a chamfer or some other way that doesn't involve creating a new plane?
I'm helping to develop a lap simulator in MATLAB. A racing course is divided into straights and corners having various lengths and arc lengths. The simulator does math to approximate lap times. I have sketched the course in SW using lines and tangent arcs to create a planar, closed profile...
Is there a shortcut to exit from "edit part" or "edit assembly" while in another assembly? I often edit parts while still in the assembly file, and I don't want to go up to the command manager to exit from "edit part"; rebuild just rebuilds the part (which it should). Any suggestions?
I have an issue with the shortcut box. It won't resize. I try to drag the edges to resize it, the mouse changes to the double-arrow, but dragging any edge in sketch, part, assembly, or drawing won't resize the box. If I add more buttons to the box, it just adds them to the bottom of my 1 column...
I want to make a drill bit organizer. It consists of sheet metal with a hole for each size of drill bit. A very basic part, I just want to know if there is a shortcut in the modeling. My plan is to linear pattern (sketch or feature) a single hole. My question is, is there a way to linear pattern...
Let me start by saying that I have not taken heat transfer yet. My question seems like it should be very basic, but I just don't know which equation to use.
I have a heat source that is 500 degrees F. If I have a heat shield at some distance away from the heat source, with air separating the...
I have a model of a very simply bracket. When I make a change to the model, then go to the drawing, the model "explodes" into the spiky sea urchin you see in the attached image. Here's my process to make it happen (it is repeatable):
-File, Open part in SW (part looks as it's supposed to)...
Is it safe to assume that an engine at X% load will make X% of the rate power at that RPM?
Example: an engine produces 100 HP at 5000 RPM at 100% load. If I reduce the load to 60%, does the engine only produce 60 HP?
I am looking for the estimated fuel consumption (gal/hr) of an engine at 60% load. I have the torque, horsepower, and fuel consumption curves, as well as various fuel system parameters (max fuel consumed at rated speed with full load). My issue is the fuel consumption curve is only given at 100%...
