Hi All
I am looking for some software which can ease my work for report making.
After inspection we are generating separate reports like UT, LPI , MPI, Hardness , PMI ( Positive material Inentification ) , Weld Sheet.
Currently we are working in Excel and every time we have to do the entry...
Hi to all
Well i just need a clear clarification regarding below situation
Case 1- I have a WPS which is P1 G1 and qualified with P43 Gr. Unassigned
Case 2- I have a WPS which is P1 G2 and qualified with P1 GI.
Impact is the requirement ( For weld as well as for HAZ )
Now ...
Hi Friends
I have a small doubt and i need experts clarification
QW-360 WELDING VARIABLES FOR WELDING OPERATORS
QW-361 General
A welding operator shall be requalified whenever a
change is made in one of the following essential variables
(QW-361.1 and QW-361.2).There may be exceptions or...
Well i came across the word " Weldability " but basically i am not having more information on this so please help me on below questions -
What is the terms " weldability " stand for ?
What are factors affecting the Weldability of a material ?
What are the weldability tests ?
What is the...
Hi friends
Well in Pipeline Radiography of a butt joint what is the acceptance criteria for Excess Penetration.
Kindly note that , we are not able to check weld joint from Inside and code we are following is API 1104.
What are the deciding factor for PWHT ( coil or Band width ) requirement.
Some specs/ codes say 75 mm , some say 50 mm , some say 150 mm. So what are the basic criteria for selecting the Width of Induction Coil?
Hi friends
Well here is the case -
After cladding of pipe and flange with all approved WPS we carried out NDT ( UT for dis- bonding and PT for open surface defects as per approved procedure with approved NDT technicians ) and same was witnessed , accepted and released by vendor inspector as...
Hi friends,
Well , one question came in my mind while discussion with some inspection engineers , that , In a butt welding , ( Joint is single V and diameter is 43" ) we are doing the GTAW in root and hot pass , so after completion of Weld , Is we need to do PT / MPI from root side ? We are...
Hi Friends,
We are doing cladding on CS materials , having thickness more then 19.05 mmm.
There is PWHT requirement for Butt weld but "Is PWHT required for Cladd welding also"?
If required then which code is recommending for this.
Kindly help !
Thanks
Hi All
Hope you all are enjoying your own day :-)
i have one confusion related to acceptance criteria for rounded indication.
As given in section viii div 1 - page 419-4.3- ( f ) Regarding Rounded Indication Charts.
Rounded Indication Charts.
The rounded indications characterized as...
