I am designing a stub acme connection, and in this case, I will be pushing its limits more than normal. I am looking for any information about load sharing between threads for 2g or 4g threads. I have read in some more basic books to use two threads with equally distributed loads, but from my...
I have been using Draftsight for a while now, and all of my drawing sheets are set up to have particular print configurations. For some reason, my newly created sheets will not maintain the specified configuration but go back to "none" whenever I restart Draftsight. The older pages will maintain...
I just rotated a letter paper in paperspace to be portrait, but the bottom left corner is not at 0,0. I cannot figure out how to get it where it is supposed to be. I am using the newest release of draftsight on Windows 7 if that makes any difference.
Has anybody ever had this problem before...
I seem to recall reading something about a maximum height for a land drilling rig, above which a dynamic structural analysis must be done. I cannot now find the reference. Does this ring a bell for anybody else?
"If it has been done... there is a better way."
When I make a generated report, sometimes (but not always) the figures of the deformed body are covered by a grey figure of the undeformed body (as shown in the attached figure). What is the deal here? How do I make it so there is not the grey body covering the results.
Thanks for your time...
I am designing a jacking roller. I am trying to find information for allowable rolling stress for materials (specifically A514 steel). Does anybody know of a reference that would contain it, or a procedure for calculating it?
Thanks.
I am trying to find a maximum of a function that calls up a function. I just can't get the syntax correct for the maximize function (I can when using it for a function of single level variables though).
I have attached the file as MathCAD 15.0, and 11.
I am looking for a high pressure/high output fan for a new R&D project. It has been a long time since I have dealt with fans. Many fans that I am coming across are giving a "Static Pressure Range =~ 300 in.wg", but then the spec sheet gives a static pressure of 5 in.wg.
What is the difference...
Mathcad users,
I have been trying to figure out how to store the values from a given/find solver block into some sort of usable array for use in later calculations. I am fairly new with mathcad, and using mathcad 15.
The code is attached.
Thanks for your help.
