Im designing a reverse trike for a project and i want to use swing arm suspensio for the rear single axle. Do i want to keep the arm as short as possible? If it is longer do i need a thicker/bigger/longer/wider spring? I was thinking of actuating it just like on a modern superbike with the...
Hi again,
Im designing a super streamlined ground vehicle and wanted to come up with an initial design geometry based on mathematically defined curves.
I came accross a method in an SAE technical paper which defined the camberline of a car airfoil shape based on the lift coefficent delta Cz...
Since usually a stagnation point would occur on the front of the vehicle nose, if we make a small hole in the nose (for a radiator for example), the stagnation points would move to the area around the hole. How does this affect the total drag.
I know there would be an increase in drag due to...
Hi,
I know how to publish dimensions inside a surface feature (e.g. extrude lim) but how can i publish one inside a sketch?
I want to do this so it makes dimensions inside a sketch easily accesible without going through dozens of tree levels to reach it.
Thanks
Rob
