New to C programming and the 8051 and I'm trying to modify a program to receive 3 bytes of data, and write those bytes to Ports 0,1,2. I'm hoping my input would be something like
000000001111111100000000 and Port 0 would show the first byte, Port 1 the second, and port 2 the last byte. I'm using...
In the attached schematic i'm trying confirm my blocking diodes are located in the right position, and if i need resistors as well.
Design goal is to put a circuit in (using diodes) that will assure the batteries dont charge each other AND if one battery goes bad, the entire system wont shut...
I'm wondering if anyone heard of a combo chipset that has a GPS receiver and a 2 or 3 axis accelerometer within the same package? Any help or direction would be appreciated!
I know i can combine two individual chip sets but wondering if anyone has made this work with each other.
Thx,
I'm whipping up a circuit that uses +15V via a standard Voltage regulator. I'd like to have the regulator shut off, or turn off, when a transient voltage is applied.
i.e. a separate DC voltage is introduced into my circuit and i want to use that to shut off the regulator.
Can a diode do this...
I've measured my prototype antenna using a known Reference Log Periodic. Test set up was the known Log pointing at my prototype Antenna Under Test (AUT) using S21 on my VNA.Cable length was calibrated out.
How do i determine the AUT's gain in dB or dBi? I thought,
i took the LogMag measured...
Is there a service that could make a Printed Circuit board in 3 dimensions? Testing a concept. Can get flexible PCB and put on a fiberglass structure, but would prefer the PCB itself shaped.
thx,
I'm prototyping a small dipole antenna from 4-6GHz and am looking for a good reference design for something in that frequency range. There are a number of chip baluns available but have a higher insertion loss. I'm etching the antenna on standard FR-4 pcb.
I'm hoping there is a "balun...
I prototyping a GPS LNA circuit that shares and antenna with a transmitter (1 watt). I'm trying to find a switch that will protect the LNA when the transmitter is on becuase the isolation is poor and i'm afraid the LNA will be blown.
If i had steady voltage i could simply use a switch and...
I'm prototyping a GPS LNA circuit and am trying to figure out a good design (that wont cause a great mismatch) that will allow me to strip off the DC and couple the RF to the LNA circuit. The RF and DC come from to coax to the antenna puck (with LNA underneath).
I know a bias tee configuration...
I'm in concept mode and wondering if i have two distinct carriers, say at 400MHz (not the freq) and one is FM modulated and the second is FSK modulated and i then run
them through a signal combiner.
Will i be able to decode both signals at the receiver?
Guessing,
PF
