Hi,
I am trying to run an equation within the parameter/formula editor of v5. The equation is used to determine the minimum length of a part based upon an angular variable and length (in other words a trigonometric equation is applied). However, whilst in its simple form the equation works as...
Hello all,
I have a question or rather I am questionning the general rule where it is considered good practice to model in a seperate Body to that of the Primary Part Body.
The reasons given are;-
1) Easier to edit
2) Easier to correct if something becomes corrupted
3) All elements can be...
Hello Gents,
I have a new discussion I would to seek opinions on and also to find out from anybody who has experience in this arena.
I am a contract designer working for a large American corporation in Canada. Recently, and based somewhat on my experience on V5 Catia, I was asked to take part...
Anybody tried using the Excel integration, I have had a few problems getting the values of the model to update in line with the values of the spreadsheet.
As an example the stored value of a variable in equation editor matches that of the spreadsheet, however, the solid remains with the...
I am designing an obscuration device for development bird strike testing of machined frames within the NLG bay of an aircraft. The device is to encompass the volume of the actual NLG. Are there any approximate equations that can be used to determine the impact stress on the steel dummy...
I am looking for a relative cost value for various grades of aluminum, including aircraft grades etc. I found a similar report for stainless steel which has proved relatively useful when comparing cost / machinability / strength etc.
I do not need specific dollar values just a relative factor...
