We need to mount an identical pair of 11 kW shaft power oil-free reciprocating gas compressors inside a 20ft shipping container.
The manufacturer recommends a typical ACI-351 type 0.6 m thick steel reinforced concrete foundation weighing 5 times the skid weight. No specific information was...
We are trying to measure the noise emitted by our products (pumps and pressure exchangers). I found some ISO and ASTM standards that describe how this is done but don't know which one is the right one to use.
I am currently looking at ASTM E2202, E1014 and ISO 3704, 2204.
Please advise on which...
I am in the process of designing a hydrostatic thrust bearing test stand for a small hydraulic turbine. The turbine's shaft will be driven with a VFD controlled spindle motor at roughly 25000RPM. Power should be less than 1kW.
I am looking for a shaft coupling that can handle this type of speed...
Dear motor & drive experts,
I am designing a test stand using components available in the US (3x460V@60Hz)that will run in Australia(3x400V@50Hz). There are several ~10hp motors on the stand that drive centripetal pumps. The motors are controlled using VFDs, so frequency is not an issue. For...
I am in the process of prototyping a constant-force solenoid for a valving application. I used 1018 steel for the flux guide and 416SS for the armature until now, but would like to improve performance by using either a Carpenter electrical iron or 1002 steel for the flux guide as well as 430FR...
