Hi All,
I have a likely simple question that I hope one of you may be able to help with (and I also hope this is the right subforum) ...
As it is I would like to connect two Kanthal A1 heating wires with each other (Ø3 and Ø1.2, at 1200 degr. C max), however, for various reasons I would...
Hi all,
I hope one of you may be able to help with this ... and that I have posted in the right sub-forum ...
As it is I have for some time now been searching for a very high purity copper electroplating process for high electrical conductivity, and have now ended up preferring...
Hi all,
I may be in need of finding some photographic stencil "raw material" like this:
https://cougartron.com/products/multi-use-stencil/
.. for etching experimentation. This particular stencil is useful due to flexibility so I would prefer a stencil with identical mechanical behavior...
Hi all,
I have an annealing chamber question that I hope one of you may be able to help with ...
As it is I will soon be in need of dead-soft annealing copper wires and to this end have built a small annealing chamber from Stainless Steel (SS) surrounded by a ceramic insulation.
Before...
... I am a bit unsure of whether or not this is the subforum to post this thread - if not I'd appreciate if you let me know ...
Hello everyone ;-)
I have for some time now been trying to find a solution for rapid etching of tracks (1-6 mm width) in very thin aluminum (<3um thickness) that is...
Hello Engineering Forums,
I will shortly be making a small press for PCB laminate fusing and to this end would appreciate a tip on which steel/"other material" type to use for the press' top and bottom plates. I've included a preliminary drawing of the press - hope it may give an idea about...
Hello All,
I hope this is the right forum to post this question ... Otherwise please feel welcome to move the thread.
As it is I have a need for increasing the copper layer on electronic PCBs and would like to know how to do this. I know it can be done by adding a DC voltage to a "bath" of...
Hello All,
I have a question that I hope one of you here can help with ... I would really appreciate if this was so ... [wink]
As it is I'm currently underways with a project where I consider embedding a Nichrome wire into a clay circular plate. The clay plate, which is Ø150 mm and 12 mm...
