I am installing a steam coil air heater to heat seal air to precipitator insulator boxes. The warm air will blow through the end of the insulator into the dirty flue gas inside the precipitator. I want to install a humidity sensor downstream of the coil to determine when a leak occurs in the...
I need to remove 2 ppm of oil from a compressed air supply. I plan to use 10 SCFM of air which was compressed using a screw type compressor to 100 psig. The compressor size is 1000 SCFM. All 1000 SCFM of air flows through standard coalescing filters, an air dryer and then an afterfilter...
The normal design for closed cycle cooling systems has a head tank on the suction of the closed cycle cooling pumps. For example here would be a typical order of equipment with water flowing through.
1. Head tank tied to suction line of pumps, tank at atmospheric pressure. Water level of tank...
When performing maintenance on ammonia system piping I assume you would close valves as needed and then start your work. Is it necessary to purge the piping before breaking into the piping? Do certain industries require this? Where do you purge to? Do you purge with air or nitrogen?
In...
