Hello,
I'm trying to simulate a mechanism on which I have two movements as follows:
1. Linear Movement in U1 through an Axial Connector.
2. Angular Movement in U1 through a Hinge Connector.
Steps
Step 1 ------------------- Movement 1. -3 inches-
Step 2 ------------------- Movement 2...
Hi Gents,
I’m machinery designer for the PVC pipe Industry, at the very beginning of this year I designed and built a Machinery to test PVC pressure pipe according to AWWAC900/05 and (or) FM Standards.
My customer is request me, and special test called Burst -the pressure rate depends on the...
Hi Gents,
I’m a machinery designer for the PVC Pipe Industry, few months ago I was involved to design a Hydrostatic Pipe Tester according to AWWA C900/5 or FM Standard. One of the special features requested by my customer was “Quick-Burst” capability using a whole pipe -6.1m / 20ft long- as a...
Dear All,
I need to figure out how can I set up this FEA, I wanna simulate a plastic pipe cooling process in a extrusion line, so basically, I have a water cooling nozzles over the surface of the pipe, they're fixed in a frame, and the pipe goes in a constant velocity passing for all the water...
Hi guys,
Im stucked trying to model a very simple FEA, I need to heat up a pvc pipe applying air convection load, to find time needed to.
I did and steady state axisymetric model, and apply a Surface Film and initial temperature by a predefined condition, but looks like the temperature never...
Dear colleagues;
Im trying to simulate a steel tube reinforced with carbon fiber linings but im stuck how can i tie shell with ccontinun elements; or how can u simulate it in the right way!
Pablo
Dear All,
Im trying to get the force needed to penetrate a PP (elasto-plastic) tube with a sharp tooth -rigid surface-, using ALE, but cant get results,instead I get huge mesh distortion. Anny suggestions?
Regards
LPUS...
Dear All,
This is my first approach to model a steel tube-like wrapped with carbon fiber laminates, exactly I don't know how can I orient the fiber layups into cylindrical coordinated system, what are the steps I need to consider, and how I tied between steel and carbon fiber.
Apologize me if...
Hi,
I'm running axisymetric contact analysis, 3 deformable parts, one of them hyperelastic, but right now i wanna transfer the results into another 3d new analyis to apply non axisymetric loads.
I know that abaqus manual says, thats no possible to transfer results from assembly instances...
Dear friends,
I’m trying to do very basics, insertion analysis of a ring in to a shaft groove, via prescribed displacement conditions to know the force required, but until the ring reaches the grove the job is aborted by a classic convergence problem, “ Time increment required is less than the...
Hello all,
Modelling a pipe-end socket thermoforming-like simulation of PVC I been found a lot of problems, exactly that I try to do is this:
http://www.youtube.com/watch?v=vDW4tSda_0U
I have DMTA test results E' and E'' against time and temperature sweep.
The question is how EXACTLY do I...
Good Morning Dear team.
Right now I’m experiencing troubles with an FEA Abaqus analysis about the thermoforming of a PVC pipe socket. Let me try to explain you in detail:
The Rieber socket forming system enables thermoforming of sockets with integrated gaskets. Rieber elastomeric gaskets are...
Hi Guys,
I just started with a new project about cam indexer design, but don´t have much information about how the design the "wedge profile", maybe somebody can help me with their experience, I´m designing the cam profile on Pro/Engineer, but I don´t understand too much how this modified...
