I have a dwg that specifies tolerances to ISO 2768mk, but has dimensions less than 0.5mm .
What tolerances to I apply to these smaller than specified dimensions?
I have a bunch of Compumotors TQ-10s I will be selling, but don't have control circuitry of motors to plug into them.
Would it harm the outputs if I plugged in power with nothing else plugged in (such as motors, control signals, etc)?
I am thinking I can at least verify some kind of...
I have hooked up (for the first time, novice here!) a HP3457a DMM to a 82350 PCI GPIB/HPIB card (running in an old PC with win98) and have loaded Agilent IO Librabry 14.0.
-The HP3457a is only recognized as a device at address 22, but no equipment ID.
-The card is recognized, and I can send...
If I measure a flat object using a lens, projecting onto a flat CCD, is there any value to using a telecentric lens? Or will a high quality enlarging lens, etc. do just as well?
I have a small Paletek 10 hp oil flooded screw compressor, and it seems to run hot oil temperature. If the ambiant is 90 degrees F the oil can be 200 or 210 F.
Is this excessive? What is the danger temperature?
Thanks!
gr
