Search results for query: *

I need some thecnical information about stepper motors (in general or particullar!!)? Also if anybody knows haw ECU can compensate the required Voltage for an steeper motor with manual throttle body?

Is there any body knows or can refer to combustion model of CH4-H2-Air mixture? I want to use it on KIVA 3V!!thread816-209174

Is there any body can explain about magnetic fuel energizer? And if really it can improve combustion efficiency? If yes how it make NOx reduced!!

Dears I have heared many explanations for flame speed comparison of different fuels in internal combustion engine. But I have never found any reference to make a sharp conclution to say CNG falme speed is lower than gasoline in the same condition. Or any diagram, test results or also...

Dears What is conversion factor for leakage rate unit Pa.m3/sec ? and what is the definition of this unit. Is it some like mass leakage rate? Any reference?

Dears Is there any body can explain what is the main reson they design and use a Schrader Valve on the returnless fuel rails. As I can imagine there is some advantage with releasing gasoline vapor when the temperature rises and flow is blocked. also if they want to repair an injector for...

I followed many activities for selecting a suitable material for valve seat inserts (especially exhaust) of a CNG-Bifuel engine, Following materials were selected, sampled and tested through engine durability procedures: 1- a cast Ni-resist (nickel added) heat resistance cast iron with...

Hi. Is it possible for an air pressure decay device make a minus value in leak test? I was testing some plastic fuel rails with 50 cm hose assembled on them. just one of them had a 10 cm hose but the volume, on the device, was set for 50s. the leakage was showd the same magnitude but minus for...

Hi. Is it possible for a pressure decay device make a minus value in leak test? I checkd some plastic fuel rails with 50 cm hose assembled on them. just one of them had a 10 cm hose but the volume, on the device, was set for 50s. the leakage was showd the same magnitude but minus for the part...

I work on full assembled fule rail validation test and want to know is it normal for a gasolin injector to have some internal leakages in low temperature (for example -30 deegrees centigrade)? nominal pressure would be 3.5 bars but I performed 5 bars.