I just received a 1982 print of a pump inducer. The part has 4 blades that are angled to the rotational centerline and are tapered from the hub to the tip (3°).
The Notes read:
1. Use .012/2° cam set
2. Generate the outer side with .012/2° curved cam
3. Generate the inner side with .012/2°...
SW 2008 Sp3
XP Pro
4mb
During some final filleting on a finished part the hour glass came on for a moment and SW closed.
Checked in the auto recovery folder and there was nothing.
Opening the part gives the following message (after the part shows on the screen):
SolidWorks encountered an...
I need to run some tests on my mechanical system which is powered by the star connected 208VAC 400Hz motor that I asked about in an earlier thread (thanks for help). As I don't have access to 400Hz power for these tests I would like to run the motor on 60Hz 3Phase. According to the FAQs, I...
I have a 208VAC 3ph motor with a internal brake. The motor schematic shows a star (wye) layout but with the common point also going to ground (not the motor case). This is a 400Hz application if that makes any difference.
My concern is that the 28VDC brake coil shares this ground and the...
I am looking for spring design info based on the valve & retainer mass and the desired engine speed. This if for an antique (1912) 4cyl 500cc FN motorcycle engine.
Any help on atmospheric valves would be useful. I believe many of the older staionary engines used a suction operated intake.
Gary10
