Is there a function in LabView or a known subVI that can solve an equation for roots using the BiSection Method?
For example, I have an equation:
lambda*e**(lambda**2)*erf(lambda) - (Cp*(TL-TM))/(L*sqrt(pi))=0
where:
erf(lambda), Cp, TL, TM, and L are known constant values that are designated...
Does anybody know of a couple of vendors that sells GC calibration standards or gas cylinders with reagents of suitable purity?
The gases I am currently looking for are:
1. Hydrogen
2. Carbon Dioxide
3. Carbon Monoxide
4. Methane
If possible, I'm looking for a QT cylinder size (US DOT Spec...
I am currently designing an exhaust manifold/duct to be used to capture a reformate and I am running into problems locating a suitable material for fabrication.
I need a material that meets the following criteria:
1. Lightweight - I need a material that is considered lightweight because the...
I was wondering if there was any software out there that can help cut down the iterative process of the Fenske-Underwood-Gilliland equations/correlations to estimate the key parameters in a distillation coumn or possibly any other software that may be helpful in distillation design and simulation?
Ok, this is a stab in the dark. Does anybody know the typical droplet size of generic spray bottles or those pump sprays (like found in hair product stuff or perfume)? I'm trying to find something out there that could simulate in the 1-20 micron range, but something tells me a spray bottle's...
I currently am designing a gas-liquid separator and I'm trying to find a manufacturer that specializes in custom mist eliminators. Because my separator is very size constrained due to the application it will be used for, the dimensions for the separator are roughly 3.25" ID diameter and roughly...
I currently am designing a gas-liquid separator and I'm trying to find a manufacturer that specializes in custom mist eliminators. Because my separator is very size constrained due to the application it will be used for, the dimensions for the separator are roughly 3.25" ID diameter and roughly...
I currently am designing a gas-liquid separator and I'm trying to find a manufacturer that specializes in custom mist eliminators. Because my separator is very size constrained due to the application it will be used for, the dimensions for the separator are roughly 3.25" ID diameter and roughly...
Ok, I have a question that I am hoping someone out there can answer. I am a fairly new engineer and I am in the process of using a VFCFRH (for short) in junction with a new catalyst to raise it up to 500 Deg. C. (Don't ask me why, because the reason keeps changing). Anywho.... I have an E...
