We designed an o-ring face groove for a .103 (inch) cross section diameter o-ring. The design groove width was in the range of .139 inch. But now I see that tooling is almost non-existent to machine this size groove (remember face seal.) Does no-one use this size o-ring for face seals? I see...
I am utilizing a DIN 5480N40x2x30x18x9H spline. Where do I find the spline data for the:
Base Diameter,
Major Diameter,
Form Diameter,
Minor Diameter ,
and the:
Circular Space Width
Max Actual,
Min Actual,
Max Effective,
Min Effective.
I looked for...
I have an application where I want to start a large inertial load, run it for a few minutes then stop it using the electric motor.
The startup cycle is a constant torque cycle going from 0 to 220 hp in six seconds. The torque goes from 0 to 9202 in-lbf in the same six seconds.
The load then...
