I have a component that is 123 +/-0.005 in width on witch there are some holes located on the centerline of part.
Some are of the opinion that because these holes are shown on the centerline of the width with the applied tolerance, that the tolerance off of the centerline is +/-0.0025
There...
I have a component which has a 1/4-20 UNC-2B thread running through it. I would like to set up a design table to drive multiple configurations. I cannot for the life of me get the table to drive the thread, too. Everything else comes in fine. Is this even possible?
SW2006 SP5.1
My company is currently considering switching from SmarTeam to PDMWorks Enterprise (formerly Conisio) for our PDM. Any Solidworks users out there using Enterprise? Tell me what you can. What are it's strengths/weaknesses? Etc...
Anybody have a generic ECO form that they are willing to share?
I have been assigned the task of creating one, and of course would rather not do it at all (if I can help it).
But, just in case no one has something generic that they are willing to share, I'll also accept suggestions for what...
I have a cylindrical part with a chamfer at each end.
Is the correct callout for this "2X 0.031 X 45°" or does each chamfer need to be noted individually?
Thanks.
