Calculates Temperature
there are (2) Loops , either computes the same answer
i prefer the 9 Loop version
'======== Copyright (c) 1995 Larry Meaux , All Rights Reserved ==============
'| |
'| Program Name: REVERSE.BAS...
very many years ago , a local oil field guy
gave me a Dwyer 0-to-10 Cubic Feet an Hour Meter
thinking i might be able to use this for something ????
What i came up was a very easy method of finding TDC
on race engines without having to use a piston TDC-stop
With the Dwyer 0-10 CFH meter , its...
Anyone here has used the "Bridge-Point" CC-Method ???
Goodson sells what i call a "deck bridge" a upside down
"U" shape that spans a cylinders bore to check the deck heights of piston's depths in bore at TDC
but you remove the 1.000" inch dial indicator...
Ivymike...i should have posted this article 1st ..but i just found it
..from SuperFlow concerning what we are discussing
Fuel Flow When Accelerating
You only have to run a few tests on an accelerating engine with your SuperFlow Dynamometer system to discover that the power output and the...
SuperFlow article.......
How accurate are the air flow measurement turbines?
Our own testing on flowbenches shows that the air flow turbines are extremely linear and quite accurate for volumetric flow measurement. The honeycomb at the top and bottom eliminates variations due to vortices and...
SuperFlow article.......
Can you avoid air and fuel flow measurement by using a Lambda sensor?
Lambda sensors are devices that measure the oxygen content of the exhaust gas to determine the Lambda ratio of carbon to oxygen. The first thing you should know about the Lambda sensor is that it must...
If anyone is interested in calculating peak horsepower,
torque from their dragracing time slips;
Choose "one" of the following methods
that you have ET Time data for
Method 1) 60,660,1320 ET
Method 2) 60 and 1320
Method 3) 660 and 1320
Method 4) 1320 only
Additional need data from...
Anyone here has dyno experience or has studied the effects
of wrist pin offset ???
And what about cylinder bore offset in either
with crank rotation or against crank rotation ???
Know the net effects ???
I've offset bored blocks along the crank axis to unshroud
larger intake valves, but never...
