I need to add a small lever to a Printed Circuit Board (PCB) to push a small plastic part with a max force of about 200g. This is part of a high impedance, low power circuit running at 0.5 A at 4.5V for 1 second with an infrequent duty cycle (in simple terms, I'm dumping 3 AAA into 1/2 ohm...
I need to set up a parts numbering system to cover electronics, hardware, enclosures, assemblies and finished goods for a small start-up that makes small electronic products. My question is are there any good top level category codes that are available so that I can avoid doing it myself from...
I'm an EE in need of some metals advice.
I need to add a small lever to a Printed Circuit Board (PCB) to push a small plastic part with a max force of about 200g. This is part of a high impedance, low power circuit running at 0.5 A at 4.5V for 1 second with an infrequent duty cycle. The power...
I am looking for any case studies or simulations showing performance differences between single zone (whole home) HVAC controls and multi-zone (room-by-room) HVAC controls. I am also interested in reports on energy savings due to the use of occupancy sensors. If there are no studies for zoned...
Would anyone care to recomend any good referance books on fluorescent ballast design? I have a special interest in electronic and dimming ballasts.
Thanks
-scott
