Hi All,
Our company is interested in fabricating structural steel supports for a upcoming SoCalGas project.
I'm trying to determine what Certifications or Approvals would be required to facilitate this type of work.
And any points of contact to get the ball rolling would be greatly appreciated...
Hello Gentlemen,
I am a Welding Inspector.
My shop has a potential client that is looking to have us weld components for
Spent fuel pool water level instrumentation.
I am concerned that we are lacking acceptance criteria.
Can anyone provide direction in regards to specs or standards dictating...
Hi All,
We are a job shop with no coating processes in house. So, we outsource our painting & powder coating.
Our vendors often assist us by packaging the finished prods. to reduce handling.
Several of our customer have recently rejected our prods. for surface scuffs & light scratching...
Hi All,
Does anyone have a spec on the designed torque load specs for 3/8-16, Hex, 3 projection, weld nuts?
I have a client that has rejected my parts due to the weld nuts failing under torque.
We used the Nut MFGs weld specs & did an informal load test. Which seemed to be sufficient, for...
I've seen ASME codes define fillet welds as "weld of approx. Triangular cross section joining (two surfaces)..." What if there were a 3rd mat'l sandwiched between the stated "two surfaces" in a lap joint condition? Would this be considered a fillet?
I'm looking for some clarification on testing a PJP groove, Procedure Qual. To Sect. IX.
Sect. IX implies that PJPs can be qualified per Table QW-451. Table QW-451 (in my humble opinion) applies to CJPs only as there is no discussion or direction for macros or removal of unfused base metal...
I have 2 questions.
I am in need of data regarding the Alum. Assoc. Docs AA ASM 35(I believe this is a design Manual.)and AA ADM 1(Perhaps another design Manual).
And their application to welding criteria.
1st Question....Do either of these Docs dictate welding Criteria.
2nd...
