I just updated SW07 from 0.0 to 2.2 and now RealView is grayed out. Any suggestions on a cause and/or remedy? The video is a Quadro FX 550. Perhaps there is simple solution to a setting that I am not aware of since this the first video card that I have used that supports RealView.
I am designing a spool valve using acrylic for the manifold
housing. There are also fluid pathways grooved in the acrylic that are somewhat complex. So the manifold housing is made from sections.
1)I need suggestions on a bonding process that can be done easily with out special equipment and...
I need suggestions on modeling a twist in a rectangular cross section.
The aluminum casting cross section is 160mm x 96mm x 10mm wall and the twist length is about 60mm. The twist angle is 12 degrees.
