Hi Guys
I'm struggling to find and published data on Aluminium AA4045
I specifically need the Tensile strength figures, can anyone assist?
Thanks in anticipation of your help.
We are currently in the design phase of a Heat Exchanger / Pressure Vessel.
The unit features Brazed Aluminium Plate & Bar Heat Exchangers.
We have dealt with a number of manufacturers but none of them are willing to comply with the ASME IX requirements for Brazing.
Does anyone know of a...
I need to prove, from an acreditted source that Aluminium in 5454, 3003, and 4045 Alloys are compatible to use with N-Hexane in both Gas and Liquid states.
Can anyone give me any pointers where to start looking?
I'm looking for a vendor of Extruded Copper tubes with internal vanes or dividers.
The tubes are around 5/8" outside diameter with a 5 legged divider, slicing the bore of the tube into Pie like segments.
I used to use a company called Turbex in California but I can't find them any more.
Any...
We have a production job to drill multiple holes in a closed box section component.
I need to countersink the inside of the box section to remove any burrs etc caused by the drilling operation.
We have tried the conventional manual internal deburrers.
I am sure that I have seen a gadget that...
I assume that exhaust emmission regulations will get a lot more stringent over the next couple of years especially in the USA.
Does anybody have any comments on what impact the new emmission regs will have on Charge Air (Inter) cooling?
Will we see air temperatures soaring and the need for...
Are Supercharger Intercoolers (Water - Air) usually cooled by the engine Jacket water or a seperate closed circuit system?
It's accepted that the seperate closed circuit system would perform marginally better due to a lower coolant temp but is it worth it for all the extra plumbing and wieght...
I've checked the FAQ's and Keywords but still can't find what I need, apologese if you guy's know better.
I have an idea that I'd like to try for a water cooled Intercooler for a supercharger. I have access to a thermal design engineer to assist my project but I have no idea of what...
I need help with the following problem;
I need to produce a plunged hole in a piece of Stainless Steel (304, Bright Annealed) 1.2mm thick, the bore of the plunged hole has to be 73mm Diameter.
Does anybody know how to calculate the maximum length of the plunging before the metal splits or...
Is anyone aware of a formal impact test for automotive radiators.
I know that the frontal area of a radiator can become damged due to careless pressure washing and in some instance impact damage from airborne stones etc as the materials are all relatively soft. I'm currently working on a unit...
