I am looking for typical sizing criteria for Sand and Oil Interceptors.
I know that the Interceptor Size is typically calculated using the following formula:
Retention Time * Waste Flow Rate = Interceptor Size
But what are typical values for Retention Time and Waste Flow Rates for various...
I am looking for typical sizing criteria for Sand and Oil Interceptors.
I know that the Interceptor Size is typically calculated using the following formula:
Retention Time * Waste Flow Rate = Interceptor Size
But what are typical values for Retention Time and Waste Flow Rates for various...
Does anyone know of any Books or On-Line Articles about Parallel Piping systems and how to calculate the system head loss?
Also does anyone have any recommendations for software programs that work well for closed loop parallel piping systems (HVAC two and four pipe systems)?
I have been having a hard time setting up Layouts to scale correctly to the scale I want (usually 1/4"=1'). I also cannot get my linetypes to transfer from my model(drawing space) to my layout and plot. Any suggestions on these areas is greatly appreciated.
I am fairly new to the HVAC world, and I am trying to get up to speed on designing heating/cooling systems (especially forced air). Can anyone recommend any good books or short week long classes that will get me headed in the right direction?
Thanks.
I am trying to draw piping Domestic Waist and Vent isometrics, and I am not doing so well. I usually switch to the SE viewpoint and go from there. I have troubles when I change directions, and start trying to draw fittings. Any Suggestions?
I am designing a combustion air system for a residential home. The Mechanical room has appliances that total 573,000 btu/hr. The General Contractor has suggested that we place two openings (12"x12")in the mechanical room wall that will feed into a small storage room that will have...
I am designing a combustion air system for a residential home. The Mechanical room has appliances that total 573,000 btu/hr. The General Contractor has suggested that we place two openings (12"x12")in the mechanical room wall that will feed into a small storage room that will have...
We need to inject sulfuric acid into the cooling water at one of our power plants. The easiest spot for us to do this is in the pipe right before the water goes to our steam condenser. The distance between the injection point and the condenser is only 5 feet. We are going to be injecting acid...
We need to inject sulfuric acid into the cooling water at one of our power plants. The easiest spot for us to do this is in the pipe right before the water goes to our steam condenser. The distance between the injection point and the condenser is only 5 feet. We are going to be injecting acid...
I am currently setting up a remote booster pump station. The booster pump is going to sit on a small concrete pad (approximately 4'x2.5'), and I need a weatherproof enclosure to cover the pump. I'm trying to stay within budget, and I figure that a prefabricated enclosure would be cheaper than...
Does anyone out there know of any good on-line Performance Monitoring Systems? I am looking into installing a Performance Monitoring system on two of our Coal Fired Units. Presently I am looking at EtaPRO by General Physics and SmartProcess by Westinghouse.....any others out there?
Thanks in...
