Search results for query: *

Hi I am trying to understand the tolerance requirement of GG. I have a hole dimension according to the image below. I need to know following point. 1. Should I add Roundness (0.15) requirement in dimension when i have GG requirement+ 2. What GG means in the dimension. Does it refere to the +-...

Hello I am wondering if someone could explain what the Motor residual torque means? I need a simple explanation. Regards NJ

Hello dear I hope it is the correct forum to discus the below question I insert a shaft to a hub according to image below, then I could calculat the friction coefficient from insertion force. This assmbly is based on the interference insertion. After shaft insertion I need to calculate the...

Hello I am not an expert in the GD&T. I want to know how do you get the values for the position tolerans? are the a standard value or you just choose by yourself? I really appreciate if someone could explain it. I attach some picture with the red marked values. Those value I am intressted to...

Hello I am using Creo parametric 4.0. I want to know if it is possible to hide parts in the master rep? each time I switched from modified rep to master rep the hiden part shows up automaticlly. I need to add a part in the master rep but I don't want to show it in the master rep. I want to use...

Hello I am working within automobile section. Our supplier can not manufacture one part according to our requirements. Now I am going to do a risk assessment/ Risk analysis. I have never done it before. I want to know if there is any standard risk assessment/risk analysis template which I can...

Hello everyone I am wondering about the true position diamter value. In my case I have two circle parts which has several hole and the coaxiality tolerance is very important between the holes. Please se the attach image. The hole is marked with black color. I have add true position value for...

Hi I am designing a fixture with steel material. I have a shaft with a diameter 6 m5. I need to have a clearance tolerance between the shaft and hole. Than I choosed hole diameter 6 mm with F8 as tolerance. Since I am not good enough in fit, limit tolerance, I want to ask you if I have choosed...