Hello,
Ihave some issues with the zoom about attention point. For this I wanted to look under preferences, 3D input devices. But the problem is that 3D input devices is grey, and so I can't select, while my colleagues can. Does anybody know what causes this?
Kind regard,
Roy Munnichs.
I have a problem in Drafting with NX 6.0.5. When you for example zoom in to a view, add some balloons, and then zoom out, not all lines are visible (they disappear). After refresh/update, the lines will be visible again. See attached pictures.
It started happening when we installed MP1. Does...
Hello,
We have a Dell PC with Windows 2000 on it. We currently use NX4 and it runs good on this system. However we want to upgrade to NX5, but it is not supported by UGS.
My question is : has anyone tried to install NX5 on a Windows 2000 system? And does it run good, because the PC that we...
Hello,
We are working with NX3 and having promblems with printing. We have a HP Designjet 100 printer/plotter, which supports PCL3. But since NX3 (and also NX4) do not support this language, the prints are awfull. I called GTAC about it and they said, that they cannot solve the issue. But...
Does anybody know how to (easy and fast create) a rectangular surface out of a set of curves? In I-deas there was this option 'surface by boundary'. I there a similar command in Nx3, except 'Through curves'?
Kind regards,
Roy Munnichs
I have a problem creating a rectangular array. When I make a block (100x100x100 mm), and then make a array of it (2 itemss in X, spacing 300), I get an error 'Tool body completely outside target body'. But this is exactly what I want.
Is there a different way to create such an array?
Regard...
Hello,
Does anybody know how to measure the perpendicular distance between a point and a face? When I use the option "Minimum distance", it does not use the perpendicular distance.
Any help is appreciated.
Regards,
Roy Munnichs.
I can't find the option hole report in NX2! According to the helpfile it should be in NX2.
Is this a standard feature which I can't find or is this an add-on program?
Any help is appreciated!
Roy Munnichs
I have the option 'cyle color wheel during part creation' enabled. But it only gives 4 colors (orange, golden orange, red, and magenta, color # 9 until 12) instead of the 15 colors that are available in the color palette. Does anybody know how I can get more colors in the part creation proces...
Hi,
Can anyone tell me how to add a rail to a variational sweep? My cross section (just 1 straight line) is rotating through the part, bus I want it to stay parallel to a certain plane.
Roy.
I got an assembly from Solid Edge V12. Is it possible to convert parts (or the complete assembly) into I-deas 10m1?
And if this is possible, is it also possible to convert the history of the parts and constraints?
