I have a drawing that dimensions the chamfer differently than I have ever seen. Instead of a length it gives a basic dimension of .536 taper on dia per inch of length. It also gives a diameter dimension .037 basic from the end of the part.
I have attached a pdf of the drawing to better show...
I am looking to find the amount of compression that a spacer made out of 1074 strip steel can withstand. Basically it is used in a plastic housing to protect the plastic from crushing when a bolt is tightend down. In this particular case the spacer would be about .295 diameter with a wall...
Hi All,
I am looking to find a "ballpark" calculation of converting tensile strength on heat treated material into a shear strength measurement. I would then test the forumla when I get the parts back.
Specifically I am looking at 1/4 diameter Pin 416 SS heat treated to Rc40. I would be...
