I am trying calculate the theoretical displacement of a mass that is fixed at one end, the other rigid due to a centrifugal force acting on a mass.
Where the other end is rigid, it subject to a tightening load against the application face, hence the centrifugal force, F has to overcome the force...
I am looking for some help.
I have a internal tapered sleeve that needs to be pushed up a solid tapered shaft (similar to old propellor methods). I need to push it up by 1mm.
I am presuming that the thickness of the sleeve in the middle is 8mm, and the length is 115mm. The angle is 5.9 degrees...
Dear All,
I am after guidance, and would like someone to check to see of I am on the right lines.
I have need a fastener that needs a preload value 70% of its yield.
Material has a yield of 600 MPa, therefore 70% is 420 MPa.
The Cross-Sectional Area of the fastener is 1000mm2 (smallest...
I am need of preventing a M42/M45./M48 Nut from coming loose during operation whilst underwater on a pumping application. It will be exposed to seawater and vibration, so has to be resitive to saltwater corrosion. 316,304 and 303 Stainless Steels can be problematic under those conditions due to...
Hi people.
I have a problem in that I need to look at.
I have a bolt that is threaded both ends with nuts on the end. The bolt goes through two coupling halves. The middle portion is bigger in diameter of the thread, a slight clearance in the hole. The bolt is hydraulically tensioned, and then...
