Hi, I'm a bit unsure about how to interpret the membrane and bending stresses at the crotch region of a nozzle attached to a cylindrical shell, specifically within the context of stress categorisation according to EN 13445-3, Annex C.
Could you clarify the correct methodology for combining...
Hallo!
What does g1 and g2 represent in EN13445-3 table A-7 figure F4 ?
Could it have something to do with the throat thickness of the fillet welds?
Thanks!
I am trying to understand the tri-axial stress state in steel welded structures and pressure vessels, etc.
When does this phenomena occur - i.e. when should i be cautious doing a stress analysis (in ansys mechanical)?
How should i check for this effect in ansys mechanical? EN13445-3 Annex C...
Suppose I have a 1'' schedule 80 pipe with a corrosion allowance (CA) of 0.126'', factoring in a 12.5% mill tolerance and using A106GrB, which leaves me with a remaining thickness of 0.0224''. While this thickness is acceptable from a pressure standpoint, I am concerned about the structural...
Hi all,
How do i determine a larson-miller regression line based on raw creep data (time, temp, stress)? The material doesnt exist in the standards.
I assume i could do a spline based of the data?
I guess what i am looking for is a larson-miller parameter calculator, but i am certain i am...
What is the yield and tensile strength of stainless steel SA-240 304L (S30403) at 900 C for a duration of < 3 hours? It is a pressure vessel subjected to a fire.
