Hello there,
I am relatively new to MSC Marc / Mentat and I'm having some difficulties applying a load using a spatial distribution.
Since the load is dependent on the nodes' x0 and y0 coordinates, I attempted to apply the load using a table, containing 2 independent variables (x0, and y0)...
Hello there,
I am relatively new to MSC Marc / Mentat and I'm having some difficulties applying a load using a spatial distribution.
Since the load is dependent on the nodes' x0 and y0 coordinates, I attempted to apply the load using a table, containing 2 independent variables (x0, and y0)...
Hi,
I'm working on a model using Siemens UGS/NX7.5 Nastran, where a solid is supported by various small cylinders.
To model this, the cylinders are modeled as spring elements, and the supporting area of each cylinder is represented on the solid as a seperate circular surface.
I've used TRI6...
Hello all,
I've been using NX Nastran for quite some time now. However, I've run into an issue which I can't seem to resolve, so I was hoping for some input.
My goal is to create a number of individual 2d elements on a polygon surface (so, not necessarily in contact with each other). Later...
Hello all,
For my graduation project I'm required to perform a non-linear transient contact analysis at this point.
I have used NX rather much but not for this type of advanced non-linear solution and I'm running into a bit of a problem.
My model consists fully of solid elements, it is neatly...
