Recent content by yutaini

Hi How can i ensure correct ring size in mass production environment? How to sort mixed ring? Ring Size as follow: ID x Thickness x OD (mm) 25 x 3 x 35 25 x 2.94 x 35 25 x 3 x 34 Thanks

Hi, I'm looking for an automated inspection tool for ceramic plate.

Hi, I'm looking for an automated inspection tool to check for cracks and edge chip off for ceramic plate. Any recommadation? Thanks.

Hi, Anyone has perform any chemical compatibility study on Viton O-Ring soak in HFE71IPA ? Will there be swelling? Will it contaminate the solvent? Can I soak Viton O-ring in HFE-71IPA? Thanks.

Hi Saxon, Yes, I using U/S washer to wash electronics components. What type of test method I should use to check if there is any surfactant resdiue left on the washed component?

Hi, What is the effect of surfactant concentration in a U/S bath when the U/S power is increase or reduce. What is the effect if the frequency is change? Is there any site that I can find this information? Thank You.

Hi Igor, Did you manage to measure the U/S power in the tank? I'm interested to know more about it.

Hi, I'm a fresh graduate that just join the workforce as a process engineer. Currently, I'm task to set the control limits for a drying process. A sensor will determine the basket temperature just before it depart the dryer, and the time between basket is about 3 mins. So only one data is...

Hi, I'm interested to know more about truck & Bus. Is there any magazine or website that i can subscrible? Thanks for the advise. Best Regards, Yutaini

Hi, I'm thinking of using hall effect to measure displacement of two plate. Is this possible? Can rekon me any web site on this. Thanks. Cheers, 417

Hi, I'm doing a report on water-lubricated journal bearing. But having difficult obtaining the relavent data/repoorts. Please advise me on where to get the data. Cheers, Yutaini

Hi, what is the effect of supplying lubricant from one end of the journal bearing and drain away at the other end as compare to the conventional way of having a supply at the centre of the braring. Cheers, Yutaini

Hi, i'm doing a project on water lubricated journal bearing. Now having problem measuring the gap (distance between the shaft and bearing). I'm currently looking at using eddy current displacenment sensor mounted in the rotating shaft but it need a reflective (metal) coating in order to...

Where can I find info on the diesel engine (in depth) on the web? I need schematics, one the operation of the journal bearing on boat motor... Regerds, Yutaini

Hi.. I'm doing a project which require me to install a pressure transducer in to a rotating shaft..I'm now looking at ways to tap the signal from the transducer on the rotating shaft. Now currently i'm thinking of using slip ring but the manufacturer of the pressure transducer warn that the...