Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by venkith

  1. venkith

    Output Requests for a free body diagram

    Thanks Jake, I was looking for the freebody from the results & not from the applied loads. -- Well, I found it! I think I did :) It is to switch on the "Grid Point Stresses & Force balance" as output requests for analysis and in results post-processing, use the "Free Body" object with the...
  2. venkith

    Composite Delamination in Nastran

    Thanks dmacx and Borowski. DMACX: Modeling as 3D layered in my case would be tedious in my case[too many variations in number of ply and properties]. But, I will use it relatively in smaller test cases. Thanks again! Borowski: I was thinking of about this method[well, I am doing it actually]...
  3. venkith

    Composite Delamination in Nastran

    Hello All, Have anyone done a Composite delamination problem in Nastram before. Any small help would help a lot. Thanks VENKIth
  4. venkith

    Output Requests for a free body diagram

    Hello, I am pretty new to this place as well as Patran. I am using MSC Patran & Nastran to do some static analysis. I was wondering, what are the output requests are needed for getting a free body diagram plot from Patran. Thanks VENKIth
  5. venkith

    Volume approximation

    well it possible. Simply meshing an outward fillet adds volume & inward reduces volume. Did I make sense? venkiTH
See more

Part and Inventory Search

Back
Top Bottom