Recent content by uwam2ie

nothing new, the safty factor post display is broken since nx8 or nx nx8.5. Do you really use the stress wizard? I like it,but expanded to design & simulation.

hi, this seem s to be a problem with the GMtoolkit, check (search for) UGII_JAVA_HOME from Help->logfile if the folder exist

color settings are part specific, that means every part has it's own color management. Preference -> Color Palette will manage, this in each part, ... seedpart.

arrangements, by arrangement specific distance or arrangement specific constraints http://www.youtube.com/watch?v=fM-TcwW0Ouo&list=UU9mi7-FkTQtLY3Fpy8C3xCg

you may have a look at arrangements. keep in mind these assembly constraints are positioning constraints - hope it helps

I had no problems, too. I would try do reset the dialog of delete face using the round arrow in the delete face dialog title, and try it again.

There are two approaches working with the pocket. Multibody library part with the boolean subtract body on the referenset false (easy). The second way is hardly connected to the (clearance) hole, using the holeseries. For this configuration there is a something simmilar to classification where...

iges is the worst point to start in nx

run the setup in the windows 7 compartibilty mode when you begin to install

extract the faces of the whole body as single face, and you see were nx has problems with catia geometry - pls contact gtac regards

Face Faced body, you may sew the single faces to sheetbody and compare this with the facet body

one is the filename in os, the other is the discription in the assembly

try this: analysis->deviation-> gauge this will use faced bodies

try this: Move you nx graphic window on the primary monitor, as (you can) defined in the graphic driver. In most drivers there is a setting to open input boxes only on one connected monitor , this will center input boxes on another monitor , check this out.

as faras I Know a project infuture versions nx10 or above