The short answer to your initial question is as far I aware there are no standards or recommended guidelines for the minimum distance for separation between a data center and substation.
It seems that you have raised a couple of issues in your post though.
The first question being whether the...
One other item although not complete the IEEE Color books are in tbe process of still being updated. The update and revision once completed will be called the IEEE 3000 Series Standards.
IEEE 3000 Standards Collection™—Coming Soon
(formerly IEEE Colorbooks® PowerPack)
The IEEE 3000 Standards...
David,
There are a few that come to mind that should be added to your original list but which I don't see yet.
This first one below was from one of my replies to another post in which you mentioned your were going to add it to the list, but which I don't believe has been so I will include it...
One of the old industry bibles for motor repair and troubleshooting has been Electric Motor Repair by Robert Rosenburg and August Hand. It is not an engineering book with lots of formulas, but it is one of the most practical books on motor operation and repair you will find. It is available on...
Currently working for a company that specializes in data center design we looked at using DC distribution several times in the past and proposed it for use on different projects, but it has never been accepteded for any of the projects I have worked on. There is still some debate about the...
There are no code requirements which specify the direction that the ground prong and hot or neutral need to be oriented. I would agree with David that if the device is listed and manufacturer instructions indicate which direction it needs to installed then you need to follow that. I am not aware...
I have used it before for grounding studies. The software is powerful and has a lot of capabilities but is not the most intuitive when it comes to the user interface compared to some other programs. If you are also using the Smart Ground Meter for measurements that data also integrates into the...
David,
The kVA or MVA method is just a simplified method for performing short-circut calculations by being able to add the equipment ratings in kVA or MVA in order to be able to calculate the equivalent short-circuit current. Nothing that great about it. I think one of the first papers was...
steveal
Below is a link to a little more scientific site at the University of North Carolina-Chapel Hill which has definitions for units of measure. It gives some insight as to where the unit may have come from.
www.unc.edu/~rowlett/units/dictJ.html
I would highly recommend the book Protective Relaying for Power Generation Systems by Donald Reimert. This book goes into great detail on protection for generators more than some of the other protective relaying texts like Blackburn (even though that is still a classic). Below is a link...
Unfortunately you can't avoid the math if you want to understand electromagnetics.
I would strongly recommend the following book though.
"A Student's Guide to Maxwell's Equations" it one of the best books on the subject and will help give you a good understanding of basics by not only...
One of the best topic specific books on protective relaying for generators that I have found besides the ABB (Westinghouse) T&D book and IEEE Stds. is the following:
Protective Relaying for Power Generation Systems by Donald Reimert and published by CRC Press. It is very comprehensive and...
Two books I enjoyed and would recommend depending on your interests are the following:
Empires of Light: Edison, Tesla, Westinghouse, and the Race to Electrify the World
ISBN-10: 0375507396
ISBN-13: 978-0375507397
Another one that is also very good although out-of-print is the following...
You may also want to take a look at the SEL website. http://www.selinc.com/bookstore/
They have a new book coming out soon titled:
Modern Solutions for Protection, Control, and Monitoring of Electric Power Systems
Edited by Héctor J. Altuve Ferrer and Edmund O. Schweitzer, III
I would also recommend EYP Mission Critical Facilities which is now a part of HP www.hp.com/go/eypmcf . They specialize in these types of studies. I would suggest contacting Bob Schuerger who is their Principal Relability Engineering and also wrote section in IEEE Gold Book on relibability...
