Recent content by turbo05

Thank you for your response.Not ACME, To clarify, I was referring to a square thread..

Myself is currently working on a project to re-engineer a damaged stem nut for a non-rising stem gate valve. The thread on this valve is a nonstandard square thread with a diameter of 1.75 inches and a pitch of 3 threads per inch. I have not been able to locate any specific standards that might...

If a steam turbine is pressurized with nitrogen at 0.2 bar during preservation, will it leak through labyrinth seal gland? Experts, please advise.

First of all thankyou very much, for immediate reply. Flow Serve/Ingersoll Dresser MakeMultistage pump,4WDXR7 Model,with7 stages. RO Feed Pump application (desalination).O&M Manual not mentioned clearly about- Which bearing is to be locked first.Hope this will suffice to proceed further...

In multistage ring section pump with anti-friction bearing type, Which bearing is to be locked first. Maximum rotor runout allowed in bearing journals,coupling. Anybody Please share your comments/advice.

In Multistage pump of Flow Serve/Ingersoll Dresser Make,4WDXR7 Model , 7 stages ,In which Near 4 th stage casing Bush & shaft sleeve design is there.In which bush got damaged.Bush to casing what type of fit & its valuee are unknown.Any body Please share your comments/advices.