Does the sudden temp increase/vibration correspond with the recycle line running @ 100%?
Could it be rotor slip?
I'd imagine that a 762mm L rotor would have a fair bit of flex when slipping and generate some good pulsations.
No signs of rubbing anywhere?
The data I need isn't dumped out to the command line, it is just shown on the screen as the program executes. I don't think you can re-direct the data when the program runs this way unless I set the shell up as an object? And eveytime I've tried to do that I fail to be able to send...
Hi,
I am trying to incorporate via VBA opening a CMD shell to run an old DOS program, enter some values and then capture the results to paste back into Excel.
So far I can open the Shell, run the program and send keystrokes as required using the below VBA code.
works = "C:\Hydoff\hydoff.exe"...
Hi All,
Looks like our workplace is going to pick up a couple of jobs where we need to create some electrical circuit dwgs showing field terminations, etc.
I've done this before using our Solidworks software and creating blocks for each component, but it's sloppy and time consuming.
Any...
Thanks Ed / Swinny.
Data didn't need to be super accurate, just looking to run some natural frequency estimations at -90°C.
I did search on here for the data that Swinny linked to, but had a brain fart and used "low temp" instead of cryogenic..... lol.
Cheers for your help as usual.
Hi all,
Any leads on where I can find some low temp data for youngs modulus of ASTM A276 316/316LSS round bar (cold drawn > 0.5" OD)?
Specifically looking for -90°C, but anything close or lower would be fine and we will just interpolate.
Data that I've found so far only goes down as low as...
How many threads are left exposed when screwed in on your new part versus the "off the shelf" part?
The bottom thread looks quite short for an NPT thread, first two threads or so are missing, this may be by design for clearance in the mating part?
Any chance you are bottoming out the tip or the...
I would think that the slip data would be IP for most manufacturers.
If you can find data with the volume/rpm for the particular blower you are looking at, manufacturers will give a chart/table with actual flow capacity at various outlet pressures.
You can then work out the slip at these exact...
This might be a good starting point : https://www.pdblowers.com/tech-talk/positive-displacement-blower-calculations/
However, you'll find slip figures are going to vary across manufacturer/models.
Probably late to the party on this one, if it's just formulas in cells you need to change rather than VBA code can you not write new VBA code to overwrite the incorrect cells with the new formula?
Open each Excel sheet, run the VBA code and your sheet will be up to date. Rinse and repeat for...
Just going off my personal experience, we seem to have very few issues drilling thin sheet with carbide drills.
To be fair though, you do need to be careful when punching through.
1.0mm sheet shouldn't be too hard if you going about it the right way.
Your biggest issue is going to be preventing whatever you use from flexing then rubbing and work hardening the S/S. If you can get a block of wood or some other sacrificial block in behind the piece you're drilling so you...
