Thanks for getting back to me. I could send you the file but I'm not sure how - on this newsgroup.
I have a 10 GA steel plate, 40 inches tall, rolled 180 degrees (15" R)(half of the cyclone barrel. The barrel axis is vertical. I then need to take an 18" diameter tube and insert it...
I am having difficulty doing cuts in sheetmetal parts that have been rolled
I am trying to design a cyclone from 10 GA. I can't figure out how to make a (correct)circular cut tangent to the main body.
I can make the cut but the cut edges are not "true" and so the sheet metal will not...
