Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by tootallbob

  1. tootallbob

    ASME Y14.24-1999 Source Control Drawing

    In ASME Y14.24-1999, what is ment by qualifications when deciding on a Source Control Drawing or an Item Control Drawing?
  2. tootallbob

    Number of Decimals in a Position FCF

    After reading over the standard countless times, I think I have found my own answer. The number of places in the FCF sould match the BASIC dimension it is associated with, not necessarily the dimension it is under. Please tell me if I am wrong, AGAIN.
  3. tootallbob

    Number of Decimals in a Position FCF

    We are still using ASME Y14.5M-1982 for our commercial drawings. I have 4 position tolerences on a drawing with three place dimensions/tolerences. When using a feature control frame on a inch dimension, does the number of decimals in the F.C.F have to be the same number as in the...
  4. tootallbob

    ASME Y14.5M-1982 # OF DECIMALS IN FEATURE CONTROL FRAME

    We are still using ASME Y14.5M-1982 for our commercial drawings. When using a feature control frame on a inch dimension, does the number of decimals in the F.C.F have to be the same number as in the dimension/tolerance it is attached to?
See more

Part and Inventory Search

Back
Top Bottom