to greenimi
My goal is that
1. in the case of width being 9.9mm (10mm-0.1mm), the center of hole lies on 4.95mm(basic dimension) from one side
2. in the case of width being 10.1mm (10mm+0.1mm), the center of hole lies on 5.05mm(basic dimension) from one side
with the positional tolerance, the...
Thank you everyone for the reply
I got this question from a friend challenging me on how to make a hole dead center regardless of the width and length variance. Therefore I do not have the application for this part in mind.
to drawoh
In your suggestion using the profile control, let's say left...
Hi Everyone,
I am new to posting but have been learning quite a lot by reading the Forum. I have two question regarding to GD&T.
In the drawing , I think method 1 would work but
Q1: I am wondering in practice how would QC people setup the datum simulator to measure it. Would it require a...
