Each of the three FT's is equipped with its own 3-valve manifold.
I too thought that maybe one of the FT's might be leaking and pulling down the DP for the other FTs. But that would take a large leak, unless one of the root valves at the FE is barely open.
thread698-332862
I am analyzing the performance of a centrifugal gas compressor equipped with a venturi flow element in the compressor discharge line. Gas MW = 11 (H2 + CO2). Flowing pressure = 650 psig. Flowing T = 340ºF. The venturi is about 30 years old. The compressor is connected in series...
Sibeen,
I'm an "old and bold" myself. ;)
TNF was accurately interpreted as torsional natural frequency.
This appears to be one of those cross-discipline issues where there's actually not a whole lot of overlap between the electrical specialists and the mechanical specialists. Traditionally...
jraef,
The original manufacturer is out of business. Parts and technical support are no longer available.
There's actually been a number of recent failures attributable to subsynchronous torsional ineraction (SSTI)and even white noise from PWM-type VFDs. This has been a fairly hot topic at...
The acronyms are widely used industry terms and have been accurately clarified above.
The OP deals with noise and unexpected torque pulsations. This is actually a very serious issue with large VFDs, can cause catastrophic failure of drive train components, and loss of millions of $$ in lost...
Hi Guys,
Do you mind if we steer the discssion back to my question regarding noise, SSTI and unexpected torque fluctuations? [bigsmile]
Does anyone have 1st hand experience with this, especially if it resulted in mechanical failures?
Sibeen...you are correct. LCI = load commutated inverter.
mike kilroy...because it's not actually a water pump. It's a turbomachine with low torsional damping. Operating on a need-to-know basis.
Gunnar,
It's possible we'll end up with a PWM design...I'm for the design producing the lowest amount of torque ripple.
But even with PWM, there will still be a concern with SSTI and white noise excitation.
jraef,
As mentioned in the OP, the existing VFD is a 12-pulse LCI drive.
As a mechanical engineer, I lean towards using a VFD with the lowest achievable torque ripple and have done a torsional analysis for a large PWM driven compressor in the past. However, others on the team lean towards...
The observed unexpected torqe spikes and fluctuations are definitely not fluid-related. They were observed during a back-to-back VFD/motor test at the motor vendors factory back in the early 1990's.
Numerous failures have been reported in the literature attributable to SSTI or white noise from...
I'm working on a project where we are planning to replace an older, non-supported VFD with a new VFD of similar 12-pulse LCI-type archtecture. The motor and driven equipment (centrifugal pump...>10,000 HP) remain unchanged. Reading through the original test report for the motor and VFD issued by...
Competitively bid the job, e.g. the GE LM2500 driving a GE pipeline compressor
In another couple of years the Solar Titan 250 may be proven enough for critical application.
