I found my answer in another thread. Thanks.
Looking back I guess my question was not clear. I was looking for the standard clearance range between the flats of a open faced wrench and a nut/bolt head (DIN 475-2). I would like to use a hex head bolt in a non traditional way and want to...
Just going to throw this out there, but any chance you would be able to let me know what the tolerance is for a 7mm wrench?
It would be greatly appreciated.
Does anyone know of a high temp (300°C) low pressure(90psi) piston seal? It will be used in a low velocity piston and must be able to hold pressure as well as move with relitivly low friction (im hoping to use aluminum components). I have an old Variseal catalog here at work that came out back...
These are the lines that i have, I would like to generate another line that is the average of these 5 lines...not a straight line, one that averages each point from each of the five lines...so essentially it will look like the others, just at an average...like this
this is somethign that i...
I don't think that excell is able to do what I am looking for it to do. I've done the same test(a clamp test) 5 different times with slightly varying max values what i want to do is to average all of the raw data together, resulting in 1 Average line. Everything that i've been able to find...
I have multiple sets of data of Force vs. Time (the times are different for each set of data), i would like to be able to average these 5 sets of data into a single line using excel. Basicly a running average between all the lines. Is this possible? or should i ask, what is the easiest way of...
