Hello All,
I need to design a Tapered Splined Joint for an application on which the shaft oscillating at 700 cycles per min to transfer the torque of 30000 in lbs torque. I am limited with available space of about 20mm Spline length. I need to be able to remove the hub periodically to...
gearcutter,
Thanks for your reply. Even I was wondering about the same.
Please let me know, If you have any other material and HT process in mind.
Shall I use the Class 5 tolerances for the ANSI spline for crowned external spline and straight matting spline ( Both flat root side fit).
-Tamgear
Thanks for your inputs.
I have modified the numbers as follows.
Dia. Pitch P 2.5
Number of Teeth N 12
Pitch Dia D 4.8 in
Face Width F 1.65 in (42mm)
Crown Height A 0.0072 in(Misalignment 0.5degrees)
I am getting 15.5 ksi compressive stress. Little fretting possible.
Material: Will...
I will go with regular spline Hob cutter. Thanks for the input.
For load calculations with Crowning, I will be using the equations from Machinery's handbook, which checks compressive stress on the sides. If you have any other source of equations, please let me know.
Should i need to have full...
Some more details on this spline, 2.5/5 Pitch, 12 Teeth external, 30 Degree Pressure angle, Flat root side fit, 35mm Face width, 1 degree misalignment. 350 HP @1000 Rpm.
I am modifying profile of 2.5/5 ANSI 92.1 Std spline to take 1 degree misalignment. There is bending and torsional load on this spline coupler. I would like to Crown the spline flanks and OD to avoid end loading during misalignment.
Shall I use std Hob cutter for hobbing this spline or should i...
