I can import any loads generated in cosmosmotion to cosmosworks , Except impact loads .
Anyone can help me to do this ?
SW2005,CM2005,CW2005
Best regard.
I have used geometryworks for some houres.
It's very powerful in making surfaces , but you HAVE TO pay too much houres to learn and use it , It has a 950 pages manual, and so it will be time consumer.
An experience which I hved obtained befor is that Geometryworks is NOT fully integrated in SW ...
We have been using cosmosfloworks2004 for 2~3 month.
So my suggestion maybe useful or maybe not.
Cosmosfloworks is a design based CFD software , so you can't get exact solution from it . It just solve problems with some considerations and this will result a good rough estimation.
We are using...
you can use camworks or solidcam.
We are using solidcam2005 now , but we have used camworks2003 before.
In comparsion of these two software I can tell you that Camworks is more fetured base and similar two solidworks in making CAM features and so it's easier rather than solidcam.
But solidcam...
I know mastercam , but it hasn't a good interface for use.
I was useing it before , but because I want just 2d machining now , I prefer to use another.
Mastercam 10 , has very very better interface , but it has some bugs which I dont risk to use that.
Did you use solidcam ?
What about that ?
I had 2 choise but,another is added
1-camworks
2-solidworks
3-solidcam
Which on is better for simple 2d and 3d models ?
for example I need to make a toolpath to machine an engine block , 150 tools are used for machining , and 200 simple 2d operations needed.
Sopme of our models in SW is too...
Two integrated CAM softwares exist
SolidCam and Camwork.
But I don't know which is better , Does anyone know ?
I need a CAM software for 2d and 3d toolpaths full integrated in solidworks 2004.
Does anyone used both of them to compare their abilities ?
Best regard.
