The best way to test that is for you to delete the Limit mate and click over to the config Icon and see if it's still there. If not then you have your answer, if so then it's something else.
You can alwasy undo or not save the file after you delete the mate.
support69 [conehead]
I had a user tell me this the other day. They were getting the same issue as you are and said what they done was they closed many windows that were open (ones that had previously been saved) and then the assembly would save fine.
So if you many windows open, close some and see if that helps...
The Green Down arrow indicates an Exploded view... if you are talking about the plus sign right where the green arrow is at, that is just part of the icon with the green arrow.
Regards,
support69 [conehead]
You can't got to a 1400 unless you are running PCI-E Motherboard. The 500 is an AGP card and uses a different slot. Yes there are PCI slots on your MB but and PCI-E slot is different and you need to have one of those... unless you are getting a new board all together.
I use the Quadro FX500 on...
Best things you can do is take screen shots of what you are seeing and try to reproduce it from time to time with RX running. This problem needs to be recorded I agree, but I understand how hard it can be to capture as well.
I do hope you guys capture this issue with both RX and Screen shots...
Have any of you called your VAR and have them look into the issue?
Ken,
I cannot explain that. Have you uninstalled and done a clean reinstall since you upgraded?
support69 [conehead]
If things start disappearing on your screen in the graphics area, then it's a graphics card/Driver issue.
Contact your VAR, because I have seeen this issue and 77.56 driver, because those that have seen this issue said this driver helped, but didn't entirely fix the issue.
SW is presently...
Been using Century Gothic in my SW as well and I am using 1680x1050 and the text still looks good... do you have the "Always display text the same size" selected - Tools\Options\Document Properties\Detailing\Annotations Display
support69 [conehead]
I don't see a multi-jog leader in SW06 SP3. I still see all the same leaders as before. I know there is an icon for Multi-jog leaders, but it's has nothing to do with Balloons from a BOM.
You can split the arrowhead and make 2 arrowheaded leaders, is that what you did?
support69 [conehead]
Varaible fillet is the way to do this. You select the edge and it gives you points along that edge. Pick each point and give a % of the fillet to go in that area. THe first and last points you specifiy the Size of hte fillet used.
support69 [conehead]
