pennpiper and Leonardobetta's comment "Such questions without details will have useless answers" are dead on bullseye. The initial inquiry posting is too broad to offer a meaningful and specific response. Obviously, there are many factors that contribute to the complexity of the piping...
Locate an Aeroquip, Parker, or other fluid fittings catalog. The catalogs usually have a pictorial explanation of the different fittings that you have identified in your post.
It appears that the installation contractor had a bad measurement or the benchmark coordinates were incorrect. Usually my firm will add an additional 6 - 12 inch length to piping spools in the X & Y pipe runs for contractor to cut to suit the desired dimension/ location. On occasion, due to...
A client's specification regarding FRP pipe and fittings reference requirement for DSC (Differential Scanning Calorimetry)testing. First time I have encountered such testing requirement. Is this test common or some rarely used test??
Appreciate any comments and thank you for your attention...
A client's specification regarding FRP pipe and fittings reference requirement for DSC (Differential Scanning Calorimetry)testing. First time I have encountered such testing requirement. Is this test common or some rarely used test??
Appreciate any comments and thank you for your attention...
I recently worked on a project at a tank farm. The client took a proactive approach and requested all pipes on the bridge to have pipe shoes (both insulated and non-insulated headers). The reason for this approach was that the product stored and distributed changed periodically per market...
Although I am not involved in the gas industry, I found the article referenced by vzeos very interesting and informative. I was intrigued by the MIC.
The description of the chemical analysis was a bit out of my league,however this is Good reading for all the pipers.
maybe he needs to test the water in his canal to see what is in it--maybe there is some unique chemical leaking into the canal that he is not aware of!!
Each time I have a question regarding pressure drops across a filter I usually contact the vendor. The sales engineer usually knows this type of information when asked. The sales engineer can convey what other users of the equipment have done to improve the life of the item (in this case a...
mechanicblues
It appears that your question cannot be answered by a single conversion equation between lux and watt/meter2
The following is an excerpt from Reference.com
Relationship between illuminance and power
"Like all photometric units, the lux has a corresponding "radiometric" unit. The...
widla
I 'googled' helium leak testing and found the web sites interesting. I have attached a site which explains about the 'over-pressure' and the 'vacuum spray' tests.
Have you tried both types of tests and which one do you currently use to test your acid piping...
JohnBreen
Was a web site to be listed in your post
I failed to see the web site that you had mentioned.
Hence, I located this one which may offer the information required by NAITSABES
www.alvenius.com
WHY ARE YOU REPLACING THE TEE??
Did the tee fail or are you attempting to correct a flow issue??
If you are replacing the tee due to flow issues than you need to adhere to the advise of the other responses and review the entire distribution piping.
Do not use a 'band-aid' approach for a...
Contact 'Solvay Interox' a large chemical supplier of hydrogen peroxide to the steel industry for passivation purposes. They can furnish a wealth of information regarding passivation using hydrogen peroxide.
It has been many years since I had contact with them but they were very helpful in...
