Thanks to all for the advice. I sucked it up and did what stevenw suggested - hacked up my cabinets and used 10" round elbows and straights. Lost some storage space, but I didn't have time to try to find someplace to make custom rectangular ducts. 10" rounds ductwork is more readily...
Thanks Drazen. The information you mention is not provided by the manufacturer in their specifications sheet. I'm assuming I simply need to maintain the equivalent of the 10" round diameter duct work which might require some cutting of the cabinet, which will make most of it unusable. This...
I'm an Electrical Engineer in need of some HVAC advice. I need to install some duct work to vent a large gas oven/range to the outside. The range calls for a 800 CFM blower. This is an inline blower to be installed in the attic space above the garage, which is adjacent to the kitchen. The...
Is it necessary to use UL listed wiring when installing low voltage wiring (CAT5, Coax, speaker, etc.) in the walls of a home under construction? Can I just use the less expensive variety that is not UL listed?
I'm not sure if I completely understand your question/problem, but you might try putting in some NOP's between the chip select and read/write operation (you'll have to determine how many based on your clock frequency) to create the necessary delay. 20 ns is the MINIMUM delay required. You can...
