If the former boiler developed pitting then there could be a problem with make up water and or water treatment. How much makeup water is going into the boiler? What kind of oxygen scavenger is in the water treatment? How often was the boiler water tested? Was there an electrical neutral...
We are looking for information and or assistance in setting up a Haber Bosch type process to produce anhydrous ammonia. Does anyone have a suggestion on where to start?
There may be some alternatives, but they are not cheap. I looked at using methylethylamine to selectively capture CO2 out of a generator exhaust stream, the beverage industries use this to capture CO2 from fermenting mash and then pump it back into the beer. However these systems are a marvel...
The temptation to ignore ventilation is powered by the prospect of reducing cooling capacity, shrinking the mechanical contractor's equipment cost. It sounds like there could be some politics involved between the church administration and the contractor. Someone once said that being involved...
More about LP gas fired IC engines:
If liquid state propane is introduced to the engine, there is change of state heat of evaporation required to vaporize the liquid, and then also roughly isenthalpic expansion which gives further charge densification. Per the Classius-Clapeyron relationship...
A couple of issues which didn't seem to be addressed previously were EtOH's air/fuel ratio, flame front speed, and also NOX emissions of higher compression engines.
If anyone has any information on these subjects I would be interested.
I am interested in modifications to an existing V8,( high...
The problem with flexible tube or hose is that the corrugations tend to carry over into the inside diameter. Instead of a simple constant velocity you have a series of "semi vena cava" restrictions. Add to that the problem of bending and resultant diameter reduction.
The fundametal relationship...
Based on the drawing there would be a notable increase in the temperature inside due to the 1/2" ring around the edge. This is getting to be more than a simple hand calculation. Do you have some software that can do thermal finite element analysis?
Sorry I have not designed such a bath, however have you gone to the site http://mha-net.org/docs/v8n2/kuznetsov/comfortable%20bath.html ?
This person seems to be knowledgeable in this matter.
Like all engineers, given enough time and money I could apply the rules of science and design such a...
Is this an electronic component of a microwave oven? Please give some details especially why you are being asked to make this calculation. I agree with dvd that empirical data will be far superior to engineering calculations in this instance. Perhaps you could make a mock-up of similar size...
There is a company nearby which burns turkey litter and then forms the ash into fertilizer granules. At that point the nitrogen is gone, leaving potash, maybe some phoshate?. This is a bypoduct, electricity generation being the main objective.
Looking at the situation from the aspect of the lathe operator the minimum inside corner radius would be the smallest radius on the carbide cutter insert that is available.
