Recent content by sparky970

How do they maintain their LO/TO documentation if the P&ID's are wrong?

We used AB 600V MCC's that had DeviceNet, lots of good features on the E3+.

I have used Guided Wave Radar probes with a teflon coating for level measurements in HCL.

You could try Hanna Instruments.

If it were me, I'd use butt splices and tape, but there are other ways.

Again, how does something burn in an oxygen free environment?

With Pyrolysis, there would be no ash since combustion did not take place. You are left with carbon black, which can be used for filters, ink, pigment, etc. I worked at a facility in the early 90's that had 2 such machines. We processed all plastics, tires, and municipal waste. Our end...

We used the indication in our plant so the operators could tell if there was flow present.

We used Micro-Motion were I used to work.

Is it feasible to use a different type of sensor. Maybe a bindicator.

Isn't that where the coyote got all his contraptions?

We use a TDL (tunable diode laser) to measure moisture in CL2

We use our calibration standard gas on a TDL analyzer that measures moisture content in CL2.

We use a N2 standard with a specific moisture content.

We have 76% and 98% acid at our plant and use all lined pipe. While all of our flanges have covers on them.