I just think that the NBIC test is a little more complex than I am ready for at this time. I am only a CWI without a lot of mathematical strength, but I am contiuosly trying.
I have three Mazak lathes with T-plus controllers. I use the Windows terminal program to up-load and down-load programs. It works fine. I'm not sure if the older 32 model controllers have the same capability. I would reccomend giving Mazak's headquarters in Kentucky a call. They have a tech...
AVOID the Teksoft ProCAM software like the plague. I have been using ProCAD/ProCAM for nine years. The software is always full of bugs, always has been. The latest version, ProCAM 2, was released in November of 2001. Here it is August of 2002 and the program still will not allow you to print...
