Don't know if it is related, but when I look at the SW Licence Manager (attached), it shows I am using two licenses, one is borrowed, and the other is pulled from the server. However, under borrowed product license tab, everything is blank. It thinks I have a license checked out, but at the...
Thanks again Dievant. I tried both "balanced" and "high performance" power settings with the same results.
I do have to retrieve a network license over a VPN connection to run Solidworks. I am not sure if that could be a problem, possibly checking on the license each time I select a command?
It is hard for me to say since I have not run Solidworks until I got this new laptop. However, in general, there seems to be a two to three second delay between the time I select any command button and when the dialog box pops up with options to proceed.
Zooming and spinning operations are...
Solidworks Rx reports "all systems go" (see attachment). I turned Open GL back off. Thanks to all for the help, but it seems to be something besides the video card/driver.http://files.engineering.com/getfile.aspx?folder=90cd2877-7953-48b0-a743-29fb4b790167&file=sw_rx.JPG
THanks Dievant. That post about the NVIDIA nView Dsektop Manager sounds exactly like my issue. However, that was something I checked before my post and found it to already be disabled.
I am struggling to find the Open GL setting under Options, but I will continue to pursue that was well.
Thanks, I was not aware of Solidworks Rx. I checked the video card, and I have the approved version of the driver, and Solidworks Rx did not find anything out of the ordinary.
I have what I believe is a big performance problem with Solidworks 2014 and my new HP ZBook 17. When I select an entity in sketch mode, as expected, I get the pop-up properties dialog window. The delay is way more than on "slower" computers I use on campus. Additionally, if I control-click...
